Skip to main content
CallQuoteQuote
A Bell 407 on the grass beside its long-line rigging.

PART 133

Helicopter external load

We fly external-load work with the Bell 407, planned around your site and your load.

A helicopter lifting a crate on a long line against a blue sky.

PART 133

Loads placed where a crane can't reach

When a site leaves no room for a crane, the Bell 407 lifts your load from above and sets it down where you need it.

A helicopter carrying a load on a long line under grey cloud.

PART 133

Your load rides beneath the helicopter

We carry your load on a long line from the Bell 407's cargo hook, rigged for that load.

Helicopter external load in Florida

Some loads belong beneath the helicopter, not inside it. We carry them on a hook or a line with our Bell 407, which is based at Boca Raton. That work is a rotorcraft external-load operation under 14 CFR § 133.1.

For developers, contractors and utilities, a lift turns a difficult site into a short flight. The load leaves one place and arrives in another, without a road, a crane or a wait.

To discuss a lift, call 1-800-889-HELI or email sales@helijetusa.com.

Why we use the Bell 407 for lifts

Our Bell 407 is a single-engine turbine helicopter with a cargo hook fitted and floats installed. It is quick to position, steady in the hover and precise over a small landing zone.

The Bell 407 lifts rooftop and HVAC units on a 50-foot longline. The most it picks up on one lift is 2,000 lb.

What it lifts on a given day depends on the load, the fuel and the weather. Tell us the weight and we will tell you how we would fly it.

Lifts over neighborhoods and city blocks, planned in full

A lift over a neighborhood or a city block is planned in full before the helicopter starts. We coordinate the operation with the FAA, agree with local officials how the area will be kept clear, and work with air traffic control where the route calls for it.

Every route and altitude is chosen so the flight stays safe for the people and property below.

A briefed crew working from one plan

Only the people the job needs are aboard: the crew and those essential to the load or the work. Everyone is briefed before takeoff on how the lift will run and what to do if anything changes.

The ground team and the pilot work from the same plan, so each pick and each release happens exactly where and when it should.

How we plan your lift with you

A lift starts with the load and the site. Tell us what the load is, its weight and dimensions, where it is now, where it needs to go and what surrounds both places.

From there we survey the area, plan the rigging and the route, and confirm the arrangements with you.

A helicopter carrying a load above a white tower.

PART 133

Loads set down on the roof in a single pick

We lower your load from above and place it on the roof in one pick, with no crane to set up on site.

A helicopter with a load on a long line beside a high-rise.

PART 133

Lifts flown close to high-rise buildings

We fly loads on a long line close to high-rise buildings, planning each city lift in full with the FAA and local officials.

PART 133

Support for recovery after a storm

When a storm has passed, we provide storm recovery support. Call 1-800-889-HELI to tell us what you need.

Questions about helicopter external load

Which helicopter do you use for external-load work?

We use the Bell 407, which is based at Boca Raton.

What is external-load work?

External-load work means carrying a load beneath the helicopter on a hook or a line rather than in the cabin. That is a rotorcraft external-load operation under 14 CFR § 133.1.

How much can the Bell 407 lift?

The Bell 407 picks up a maximum of 2,000 lb on one lift. What a given day will carry still depends on the load, the fuel, and the weather. Send us the weight and dimensions and we will confirm how we would fly it.

Can you lift over a city or neighborhood?

Yes, with planning. We coordinate with the FAA and local officials to keep the area clear, and we work with air traffic control where needed.

Can anyone ride along on a lift?

Only the crew and the people essential to the load or the work are aboard, and everyone is briefed before takeoff.

What do you need from us to plan a lift?

We need to know the load, its weight and dimensions, the pickup and delivery sites and what surrounds them.

How do I start?

Tell us about the load and the site. Call 1-800-889-HELI or email sales@helijetusa.com.

PART 133

Steady in the hover over your site

The Bell 407 holds steady in the hover while we lower your load into place, exactly as the lift was planned.

1-800-889-HELI

Tell us about your next lift

Send us the load and the location, and we will respond promptly.